Brocade Network Advisor Migration Guide v11.1x (53-1002321-01, May 2011)
Table Of Contents
- Brocade Network Advisor
- In this guide
- Feature support
- Network Advisor packages
- Management server and client ports
- System requirements
- Migration paths
- Pre-migration requirements
- Installing the application
- Cross operating system migration
- DCFM migration
- Network Advisor migration
- Network Advisor 11.0.X to 11.1.X command mapping
- Cross flavor migration
- Unsupported server migration
- Configuring an explicit server IP address
- IPv6 troubleshooting
- Syslog troubleshooting
- Uninstallation
Brocade Network Advisor Migration Guide 39 of 82
53-1002321-01
DCFM migration
15. Complete the following steps on the Start Server screen.
FIGURE 10 Start Server screen
a. Select the Start SMI Agent check box, if necessary.
Only enabled if you enabled SMI Agent on the SMI Agent Configuration screen.
b. Select the Start SLP check box, if necessary.
Only enabled if you enabled SMI Agent on the SMI Agent Configuration screen.
c. Select the Start Client check box, if necessary.
d. Click Finish.
After all of the services (Server, SLP, SMI Agent and Network Advisor Client) are started, the Log In dialog
box displays.
16. Enter your user name and password.
The defaults are Administrator and password, respectively. If you migrated from a previous release, your
username and password do not change.
17. Click Login.
18. Click OK on the Network Advisor Login Banner.
NOTE
When migrating from an earlier version of DCFM, you must wait 10 minutes before querying the Network Advisor
SMI Agent because some of the information is not populated until after the next discovery cycle.