Brocade Secure Fabric OS Administrator's Guide - Supporting Fabric OS v3.2.0, v4.4.0, v5.0.1, v5.1.0, 5.2.0, and 5.3.0 (53-1000244-02, June 2007)

84 Secure Fabric OS Administrator’s Guide
53-1000244-02
B
secAuthSecret admin /
fabricAdmin
Displays, sets, and removes secret key information from
the database or deletes the entire database.
Both Any
secCertUtil admin /
fabricAdmin
Manages third-party PKI-based SSL certificates in the
switch.
Both Any
secDefineSize admin /
fabricAdmin
Displays the size of the defined Secure Fabric OS
database.
Both Any
secFabricShow admin /
fabricAdmin
Displays Secure Fabric OS-related fabric information.
See “Displaying General Secure Fabric OS Information”
on page 59.
Secure mode Any
secFCSFailover admin /
fabricAdmin
Transfers the role of the primary FCS switch to the next
switch in the FCS policy. See “Failing Over the Primary
FCS Switch” on page 41.
Secure mode Backup FCS
switch
secGlobalShow admin /
fabricAdmin
Displays current state information for Secure Fabric OS,
such as version stamp and status of transaction in
progress.
Both Any
secHelp admin /
fabricAdmin
Displays a list of Secure Fabric OS commands. To use,
enter the secHelp command at the CLI prompt.
Both Any
secModeDisable admin /
fabricAdmin
Disables secure mode. See “Disabling Secure Mode” on
page 79.
Secure mode Primary FCS
switch
secModeEnable admin /
fabricAdmin
Enables secure mode. See “Enabling Secure Mode” on
page 34. This command cannot be entered if secure
mode is already enabled unless all the FCS switches
have failed.
Nonsecure mode
Available in secure
mode if no FCS
switches are left
Enter from
intended
primary FCS
switch
secModeShow admin /
fabricAdmin
Displays current mode of Secure Fabric OS. See
“Displaying Status of Secure Mode” on page 62.
Both Any
secNonFCSPasswd admin /
fabricAdmin
Sets non-FCS admin account password. See “Modifying
the Non-FCS Switch Admin Password” on page 67.
Secure mode Primary FCS
switch
secPolicyAbort admin /
fabricAdmin
Aborts all policy changes since changes were last saved.
See “Aborting All Uncommitted Changes” on page 58.
Both Primary FCS
switch
secPolicyActivate admin /
fabricAdmin
Activates all policy changes since this command was
last issued. All activated policy changes are stored in
the active policy set. See “Activating Changes to Secure
Fabric OS Policies” on page 56.
Both Primary FCS
switch
secPolicyAdd admin /
fabricAdmin
Adds members to a policy. See “Adding a Member to an
Existing Policy” on page 56.
Both Primary FCS
switch
secPolicyCreate admin /
fabricAdmin
Creates a policy. See “Creating Secure Fabric OS
Policies Other Than the FCS Policy” on page 42.
Both Primary FCS
switch
secPolicyDelete admin /
fabricAdmin
Deletes a policy. See “Deleting a Policy” on page 57. Both Primary FCS
switch
secPolicyDump admin /
fabricAdmin
Displays the Secure Fabric OS policy database. See
“Viewing the Secure Fabric OS Policy Database” on
page 60.
Both Primary or
backup FCS
switch
TABLE 1 Secure Fabric OS Commands (Continued)
Command Role Description Secure Mode or
Non-Secure Mode?
Which Switches
in Secure
Mode?