Brocade Secure Fabric OS Administrator's Guide - Supporting Fabric OS v3.2.0, v4.4.0, v5.0.1, v5.1.0, 5.2.0, and 5.3.0 (53-1000244-02, June 2007)

38 Secure Fabric OS Administrator’s Guide
53-1000244-02
3
switch:admin> secmodeenable --lockdown=scc --currentpwd --fcs "*"
Your use of the certificate-based security features of the software
installed on this equipment is subject to the End User License Agreement
provided with the equipment and the Certification Practices Statement,
which you may review at http://www.switchkeyactivation.com/cps. By using
these security features, you are consenting to be bound by the terms of
these documents. If you do not agree to the terms of these documents,
promptly contact the entity from which you obtained this software and do
not use these security features.
Do you agree to these terms? (yes, y, no, n): [no] y
This command requires Switch Certificate, Security license and Zoning license
to be installed on every switch in the fabric.
PLEASE NOTE: On successful completion of this command, login sessions may be
closed and some switches may go through a reboot to form a secure fabric.
Non-FCS admin password will be set the same as FCS admin password.
ARE YOU SURE (yes, y, no, n): [no] y
Please enter current admin account password:
Enabling secure mode, this may take several minutes, please wait...
Secure mode is enabled.
switch:admin>
The command requests active consent to the terms of the license, requests the identity of the
FCS switches, and requests the new passwords required for secure mode.
7. Skip this step if you used the
--quickmode or --currentpwd options; otherwise, type the
following passwords at the prompts, using passwords that are different from the default values
and contain between 8 and 40 alphanumeric characters:
- Root password for the FCS switch
- Factory password for the FCS switch
- Admin password for the FCS switch
- User password for the fabric
- Admin password for the non-FCS switches
NOTE
The root and factory accounts are disabled on the non-FCS switches. If either of these logins is
attempted on a non-FCS switch, an error message is displayed.
For example, to enter passwords after enabling secure mode:
Changing password for root
New FCS switch root password:
Re-type new password:
Changing password for factory
New FCS switch factory password:
Re-type new password:
Changing password for admin
New FCS switch admin password:
Re-type new password:
Changing password for user
New fabric wide user password:
Re-type new password: