Brocade Fabric OS Command Reference Manual Supporting Fabric OS v6.3.0 (53-1001337-01, July 2009)

Fabric OS Command Reference 105
53-1001337-01
configDefault
2
Note that configDefault does not completely remove all FCIP tunnels and GbE IP address
information. This may be an issue when attempting to use the same information to create new
tunnels or modify the existing ones.
When issuing configDefault on the Brocade 7500 or on the FR4-18i blade, it persistently disables
the ports.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability” for details.
Operands This command has the following operands:
-fid FID Specifies the Fabric ID of the logical switch for which to reset the
configuration. This operand is valid only in Virtual Fabric mode, and the
executing account must have chassis permissions.
-all Restores all non-persistent configuration parameters to factory defaults
(switch and chassis parameters).
Examples To restore all system configuration parameters to default values:
switch:admin> configdefault -all
Executing configdefault...Please wait
Committing Configuration ...done.
See Also snmpConfig, configure, configureChassis, switchDisable, switchEnable