Brocade Fabric OS Command Reference Manual Supporting Fabric OS v6.3.0 (53-1001337-01, July 2009)

164 Fabric OS Command Reference
53-1001337-01
cryptoCfg
2
--resume_rekey Resumes a suspended re-key session for a specified disk LUN at the
termination point. A re-key session may terminate prematurely due to
unrecoverable medium or hardware errors. When a re-key session terminates
prematurely, the system logs CRITICAL RASlog and re-key operation failure
status messages. You must take corrective action to clear all error conditions
that caused the re-key failure before resuming a suspended re-key session.
All DEK or HA cluster members must be online and reachable for this
operation to succeed.
crypto_target_container_name
Specifies the name of the CTC to which the LUN belongs.
LUN_Num Specifies the number of the LUN to be re-keyed. Use --show -container for a
list of LUN numbers associated with the specified CTC.
initiator_PWWN Specifies the initiator port WWN for the specified LUN.
--discoverLUN Performs LUN discovery. This command discovers and displays all LUNs that
are discoverable by the initiators of a specified CTC. This command is valid
only on the node that hosts the CTC. The following operand is required:
crypto_target_container_name
Specifies the name of the CTC.
--show -container Displays all CTCs in the encryption group. This command is valid on all nodes.
The following operands are supported:
-all -cfg Displays the configuration for all containers in the encryption group.
-all -stat Displays the runtime status for all containers hosted on the local node only.
crypto_target_container_name
Displays information for the specified CryptoTarget container. If the -stat
parameter is specified with this operand, the CTC must be hosted on the local
node.
-cfg Displays the configuration for the specified CTC.
-stat Displays the runtime status for the specified CTC.
--show -tapepool Displays configuration information for specified tape pools when used with
the -cfg option. Displays runtime status information for specified tape pools
when used with the -cfg option. This command is valid on all nodes. The
following operands are supported:
-all -cfg Displays configuration information for all configured tape pools in the
encryption group.
-all -stat Displays runtime status information for all configured tape pools in the
encryption group.
-label pool_label | -num pool_num
Displays tape pool configuration or runtime status information for a single
tape pool specified either by a tape pool label or a number. These operands
must be used with either the -stat or the -cfg option.
-cfg | -stat Displays either configuration information or runtime status for the
specified tape pools.