Brocade Fabric OS Command Reference Manual Supporting Fabric OS v6.3.0 (53-1001337-01, July 2009)

Fabric OS Command Reference 199

53-1001337-01

enclosureShow

Displays attributes of the switch enclosure.

Synopsis enclosureshow attribute

Description Use this command to display attributes of the switch enclosure, including the vendor-specific

enclosure identifier and the identifier of the enclosure interface to which the switch is attached.

This command applies to products that are embedded in a blade server or storage chassis. Most

options are platform-specific. Options that do not apply to a platform are identified with a “Not

supported on this platform” message.

Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may

be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command

Availability" for details.

Operands This command has the following operand:

attribute Specifies the enclosure attribute. Valid attributes include the following:

id The vendor-specific enclosure identifier.

modelname The vendor-specific enclosure model name.

slotid The identifier of the enclosure interface to which the switch is attached.

rackname The name assigned by the enclosure manager to the rack.

rackid The serial number assigned by the enclosure manager to the rack.

enclosurename

The name assigned by the enclosure manager to the enclosure.

enclosureid The serial number assigned by the enclosure manager to the enclosure.

connname The product name used by the enclosure manager for the switch model.

connaddr The connector address used by the enclosure manager for this switch

(indicates the physical position of the switch in the enclosure).

connid The serial number of the switch used by the enclosure manager (not to be

confused with the Factory Serial Number).

conntype The connector type used by the enclosure manager for this model of switch.

connloc The switch location within the enclosure.

connpres Information about the switch’s presence that is used by the enclosure

manager.

connfuse Information about whether or not the switch has a fuse.

Examples To display the identifier of the enclosure interface to which the switch is attached:

switch:admin> enclosureShow slotid

Bay 4