Brocade Fabric OS Command Reference Manual Supporting Fabric OS v6.3.0 (53-1001337-01, July 2009)

204 Fabric OS Command Reference

53-1001337-01

errFilterSet

Sets a filter for an error log destination.

Synopsis errfilterset [-d “destination"][-v severity]

Description Use this command to set a filter for an error log destination. A filter is set based on the severity level

of the messages.

If no parameters are specified, this command displays the filters that are currently in use.

Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may

be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command

Availability" for details.

Operands This command has the following operands:

-d destination Specifies the destination for the filter. The string console is the only valid

value at this time.

-v severity Specifies the minimum severity level of the message to pass through the

filter. Valid values are INFO, WARNING, ERROR, or CRITICAL. Input values are

not case-sensitive.

Examples To display the current filter settings:

switch:admin> errfilterset

console: filter severity = WARNING

To set the filter severity level for the console:

switch:admin> errfilterset -d console -v warning