Brocade Fabric OS Command Reference Manual Supporting Fabric OS v6.3.0 (53-1001337-01, July 2009)

Fabric OS Command Reference xxix
53-1001337-01
• Description of any troubleshooting steps already performed and the results
• Serial console and Telnet session logs
• syslog message logs
2. Switch Serial Number
The switch serial number and corresponding bar code are provided on the serial number label,
as shown here:
:
The serial number label is located as follows:
The serial number label is located as follows:
• Brocade 300, 4100, 4900, 5100, 5300, 7500, and Brocade Encryption Switch—On the
switch ID pull-out tab located inside the chassis on the port side on the left
• Brocade 7500E, 7800, and 8000--On the pull-out tab on the left side of the port side of
the switch
• Brocade 5000—On the switch ID pull-out tab located on the bottom of the port side of the
switch
• Brocade 7600—On the bottom of the chassis
• Brocade 48000—Inside the chassis next to the power supply bays
• Brocade DCX—On the bottom right on the port side of the chassis
• DCX-4S—On the port side of the chassis, on the lower right side and directly above the
cable management comb.
3. Use the licenseIDShow command to display the switch WWN.
If you cannot use the licenseIDShow ommand because the switch is inoperable, you can get the
WWN from the same place as the serial number, except for the Brocade DCX. For the Brocade DCX,
access the numbers on the WWN cards by removing the Brocade logo plate at the top of the
non-port side of the chassis..
Document feedback
Quality is our first concern at Brocade, and we have made every effort to ensure the accuracy and
completeness of this document. However, if you find an error or an omission, or you think that a
topic needs further development, we want to hear from you. Forward your feedback to:
[e-mail]
Provide the title and version number and as much detail as possible about your issue, including the
topic heading and page number and your suggestions for improvement.
*FT00X0054E9
FT00X0054E9