Brocade Fabric OS Command Reference Manual Supporting Fabric OS v6.3.0 (53-1001337-01, July 2009)

Fabric OS Command Reference 293

53-1001337-01

ficonCupShow

Displays FICON-CUP parameters for a switch.

Synopsis ficoncupshow fmsmode

ficoncupshow modereg [bitname]

ficoncupshow MIHPTO

Description Use this command to display FICON-CUP (Control Unit Port) parameters for a switch.

Note The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may

be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command

Availability" for details

Operands This command has the following operands:

fmsmode Display the FICON Management Server (FMS) mode for the switch.

modereg Display the FICON-CUP mode register. If no operand is specified, all mode

then only the value of that bit is displayed. A value of 1 indicates that a given

mode register bit is set, and 0 indicates that it is not set.

The following operand is optional:

bitname Displays the specified mode register bit as either set (1) or not set (0). Valid

values for bitname are:

POSC Programmed offline state control

UAM User alert mode

ASM Active=saved mode

DCAM Director clock alert mode

ACP Alternate control prohibited

HCP Host control prohibited

MIHPTO Displays the FICON-CUP missing interrupt handler primary timeout (MIHPTO)

value in seconds.

Examples To display the FMS mode for the switch:

switch:user> ficoncupshow fmsmode

fmsmode for the switch: Enabled

To display the mode register for the switch:

switch:user> ficoncupshow modereg

POSC UAM ASM DCAM ACP HCP

------------------------------

1 0 1 1 1 0