Brocade Fabric OS Command Reference Manual Supporting Fabric OS v6.3.0 (53-1001337-01, July 2009)

Fabric OS Command Reference 331
53-1001337-01
fwConfigure
2
In Access Gateway mode, only the following classes are supported. F/FL_Port (Copper) class is
supported only on Embedded platforms.
.
Notes This command requires a Fabric Watch license.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
Not all platforms support fans or power supplies. If you attempt to configure values for these items
the following displays: "ERROR: No threshold available.
TABLE 15 Access Gateway mode
Class Area
Environmental Temperature
Fan*
Power Supply*
SFP Temperature
RXP
TXP
Current
Voltage
Port Link failure
Sync loss
Signal loss
Protocol error
Invalid words
Invalid CRCs
RX Performance
TX Performance
State Changes
Fabric E_Port downs
Fabric reconfigure
Domain ID changes
Segmentation changes
Zone changes
Fabric<->QL
Fabric logins
SFP state changes
FFL_Port (Optical Same as Port class
FFL_Port (Copper) Same as Port class
Resource class Flash area
EE Performance Monitor Invalid CRCS
RX Performance
TX Performance
Filter Performance Monitor Customer Defined
Resource Flash