Brocade Fabric OS Command Reference Manual Supporting Fabric OS v6.3.0 (53-1001337-01, July 2009)

Fabric OS Command Reference 429

53-1001337-01

iscsiChipTest

Performs functional test of components in iSCSI complex.

Synopsis iscsichiptest --slot slotnumber -testtype type -unit GigEports

Description Use this command to verify the memory of the network processor and iFlipper FPGA.

Notes This command is supported only on the Brocade FR4-16IP blade. On all other platforms, this

command displays the message:

“Command not applicable to this platform. SKIPPED!”

The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may

be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command

Availability" for details.

Operands This command has the following operands:

--slot slotnumber Specifies the slot number for which to run the diagnostics. The default is set

to 0 and designed to operate on fixed-port-count products.

-testtype type Selects the test type to run. By default, the command runs all tests. Valid

values are:

0 All of the following tests.

1 BCM 1125H SRAM test.

2 iFlipper internal register test.

-unit GigEports Specifies the GbE port to test. By default, all GbE ports in the specified slot

are tested. Specify a value in the range of 0 - 7 or specify 8 for all ports.

Examples To run iscsichiptest:

switch:admin> iscsichiptest --slot 7 -unit 1 -testtype 0

Running iscsichiptest ..............

Test Complete: iscsichiptest Pass 1 of 1

Duration 0 hr, 3 min & 12 sec (0:3:12:511).

passed.