Brocade Fabric OS Command Reference Manual Supporting Fabric OS v6.3.0 (53-1001337-01, July 2009)

590 Fabric OS Command Reference
53-1001337-01
portCfg
2
-p Control L2 CoS
Specifies the pL2_Class_of_Service/Priority for the FCIP control
connection as defined in the IEEE 802.1p specification. The range is 0-7.
The default is 0.
-P L2 CoS
Specifies the PL2 Class of Service/Priority for the FCIP data connection
as defined in the IEEE 802.1p specification. The range is 0-7. The default
is 0.
-bstr 0|1 Enables (1) or disables (0) Byte Streaming on the specified tunnel. Byte
streaming allows the Brocade switch to communicate with third party
WAN optimization hardware. The WAN optimization hardware connects
on the GbE ports configured for FCIP.
-ipsec policy _ID Specifies the Internet Protocol security (IPSec) policy number to be used
on the specified tunnel. This option must be used together with -ike and
-key.
-ike policy_ID Specifies the Internet Key Exchange (IKE) policy number to be used on
the specified tunnel. This option must be used together with -ipsec and
-key.
-key preshared_key
Specifies the preshared key to be used during IKE authentication. Specify
a double-quoted string of alphanumeric characters between 12 and 32
bytes in length. This argument must be used together with -ike and
-ipsec.
NOTE: Only a single IPSec-enabled tunnel can be configured on a port. No
other tunnels (IPSec or otherwise) can be configured on the same port.
Jumbo frames are not supported on secure tunnels. Only a single route is
supported on an interface with a secure tunnel.
-b comm_rate Modifies the committed traffic rate on the FCIP tunnel in Kbps. Valid
range is 1,544 to 1,000,000. Specify 0 for an uncommitted tunnel.
Uncommitted tunnels compete for bandwidth. Changing the comm_rate
is potentially disruptive. This operand is valid only with the fciptunnel
modify command.
qosmap Modifies (or resets to default), the VC to QoS mapping for a particular FCIP
tunnel. This table can be modified at any time without bringing down the
tunnel. The FCIP tunnel must be configured with the fciptunnel create/modify
-M option before the actual mapping occurs.
The following operands are supported with the fciptunnel qosmap option:
tunnel_id Specifies the tunnel ID. The valid range is 0-7.
-default Resets or sets the VC QoS map to default values.
-delete Deletes the associated QoS map configuration file. You must delete QoS
mappings before downgrading to pre-v6.0.0 firmware versions that do not
support QoS mapping. This command removes the file from the configuration
flash memory only. The file is automatically reset to defaults if later used or
modified.
vc_num When modifying the VC QoS map, specifies the virtual channel ID for
which the QoS map is modified. Valid values are 0 - 15.