Brocade Fabric OS Command Reference Manual Supporting Fabric OS v6.3.0 (53-1001337-01, July 2009)

Fabric OS Command Reference 627
53-1001337-01
portCfgShow
2
portCfgShow
Displays port configuration settings.
Synopsis portcfgshow
portcfgshow [slot/]port
portcfgshow option [slot/][ge_port] [arguments] [optional_arguments]
Description Use this command to display the current configuration of a port. The behavior of this command is
platform-specific; output varies depending on port type and platform, and not all options are
supported on all platforms.
“Non-GbE port displays” on page 627
If no operand is specified, this command displays port configuration settings for all ports on a
switch, except Gigabit Ethernet (GbE) ports.
“Displays supported on the Brocade 7800 /FX8-24 and on the Brocade 7500/7500E/FR4-18i
platforms” on page 630
Use this command with optional arguments to display the following FCIP parameters configured for
a GbE port on the Brocade 7800/FX8-24 and on the Brocade 7500/7500E/FR4-18i platforms.
• IP interfaces on the GbE port
• Static routes on the IP interfaces
• Address resolution protocol (ARP) entries
“Displays supported only on the Brocade 7500/7500E/FR4-18i platforms” on page 630
• Fibre Channel over IP (FCIP) tunnel configuration settings
- IKE and IPSec policy information
- QoS mappings
• Port Mode information
• VLAN tag configuration
• Inband Management IP addresses and routes configured on the Brocade 7500
Non-GbE port displays
The following information is displayed when the command is issued for all ports or for a specific
port:
Area Number Displays the port area number. This field is displayed only when portCfgShow
is executed for a specific port.
Speed Displays Auto for auto speed negotiation mode, or a specific speed of 1, 2, 4,
or 8 Gbps. This value is set by the portCfgSpeed command.
Fill Word Displays 0(Idle-Idle) or 1(arbff-arbff). This parameter is set by the
portcfgFillword command.
AL_PA Offset 13 Displays (...) or OFF when the arbitrated loop physical address (AL_PA) on the
port is configured to use a 0x0 AL_PA address (default). Displays ON when
the address configuration is 0x13 AL_PA. This value is set by the portCfgAlpa
command.