Brocade Fabric OS Command Reference Manual Supporting Fabric OS v6.3.0 (53-1001337-01, July 2009)

Fabric OS Command Reference 629
53-1001337-01
portCfgShow
2
EX_port. Displays ON when the port is configured as an EX_Port. Otherwise displays (..)
or OFF. This value is set by the portCfgExPort command.
Mirror Port Displays ON when Mirror Port is enabled on the port. Displays (..) or OFF when
Mirror Port is disabled. This value is set by the portCfg mirrorport command.
FC Fastwrite Displays ON when FC Fastwrite is enabled on the port or (..) or OFF when
disabled. Fastwrite is disabled by default. This value is set by the portCfg
fastwrite command.
Rate Limit Displays ON when ingress rate limit is set on the port or (..) or OFF when the
ingress rate limiting feature is disabled. This value is set by the portCfgQos
--setratelimit command. The default value is OFF.
Credit Recovery Displays ON when Credit Recovery is enabled on the port. Displays (..) or OFF
when the feature is disabled. This value is set by the portCfgCreditRecovery
command. The credit recovery feature is enabled by default, but only ports
configured as long distance ports can utilize this feature.
Port Auto Disable Displays On when the Auto Disable feature is enabled on a port. Displays (..)
or OFF when the feature is disabled. This feature causes ports to become
disabled when they encounter an event that would cause them to reinitialize.
This feature is enabled by the portCfgAutoDisable command. The feature is
disabled by default.
F_Port Buffers Displays the number of configured F_Port buffers. Displays (..) or OFF if no
buffers are configured. The buffer value is set by the portCfgfPortbuffers
command.
Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may
be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command
Availability" for details.
The Fabric OS port configuration commands are not supported on FcoE ports. Use fcoe --cfg to
configure FCoE ports.
Operands This command supports the following operands:
slot For bladed systems only, specifies the slot number of the port to be
configured, followed by a slash (/).
port Specifies the number of the port to be displayed, relative to its slot for bladed
systems.
ge_port Specifies the GbE port to be displayed. On the Brocade 7500, 7500E, and
FR4-18i, the GbE ports are numbered ge0 and ge1.
On the Brocade 7800, ge0-ge5 are 1 Gbps Ethernet ports. On the FX8-24,
there are 10 1 Gbps Ethernet ports numbered ge0-ge9, and there are two 10
1 Gbps Ethernet ports numbered xge0 and xge1.
Use portCfgshow with one of the following options and optional arguments to display specific
FCIP-related parameters configured for a GbE port: