Brocade Fabric OS Command Reference Manual Supporting Fabric OS v6.3.0 (53-1001337-01, July 2009)

690 Fabric OS Command Reference
53-1001337-01
portShow
2
The following general information is displayed when the command is issued for a non-GbE port
without additional arguments:
portName Name assigned to the port by the portName command.
portHealth Current health of the port (requires a Fabric Watch license).
Authentication Authentication type and associated parameters (ifapplicable) used on the
port at port online.
None No authentication was performed.
FCAP FCAP authentication was performed.
DHCHAP DHCHAP authentication was performed. Also displays DH group and hash
type used for authentication.
portDisableReason
Provides an explanation for the port's disabled status, if it has not been
disabled by portDisable or portCfgPersistentDisable.
portCFlags Port control flags.
portFlags A bit map of port status flags, including information on the type of port,
whether it is fully online, and whether logins have been accepted.
portType The port's type and revision numbers.
portState The port's SNMP state:
Online Up and running.
Offline Not online, see portPhys for more detail.
Testing Running diagnostics.
Faulty Failed diagnostics.
Persistently Disabled
Persistently disabled.
Protocol Protocol used by the port: FC or FCoE.
portPhys The port's physical state:
No_Card No interface card present.
No_Module No module (GBIC or other) present.
No_Light Module is not receiving light.
Mod_Inv Incompatible vendor or module speed mismatch.
No_Sync Receiving light but out of sync.
In_Sync Receiving light and in sync.
Laser_Flt Module is signaling a laser fault.
Port_Flt Port marked faulty.
Diag_Flt Port failed diagnostics.
Lock_Ref Locking to the reference signal.
portScn The port’s last State Change Notification.