Brocade Fabric OS Command Reference Manual Supporting Fabric OS v6.3.0 (53-1001337-01, July 2009)

Fabric OS Command Reference 695
53-1001337-01
portShow
2
Parity_err: 0 Ols_in: 0
2_parity_err: 0 Ols_out: 2
CMI_bus_err: 0
Port part of other ADs: No
To display an FCoE port:
switch:admin> portshow 11/1
portName:
portHealth: HEALTHY
Authentication: None
portDisableReason: None
portCFlags: 0x1
portFlags: 0x2cb03 PRESENT ACTIVE F_PORT G_PORT U_PORT LOGICAL_ONLINE
LOGIN NOELP LED NSREG ACCEPT FLOGI
portType: 17.0
portState: 1 Online
Protocol: FCoE
portPhys: 6 In_Sync portScn: 32 F_Port
port generation number: 0
portId: 036100
portIfId: 43b20029
portWwn: 20:61:00:05:1e:40:34:00
portWwn of device(s) connected:
Distance: normal
portSpeed: 10Gbps
Function Port display commands supported on the Brocade 7800/FX8-24 and on the Brocade
7500/7500E/FR4-18i platforms
Syntax portshow option [slot/]ge_port [optional_args]
Description Use this command to display the local IP interfaces and static routes on the Brocade 7800/FX8-24
and on the Brocade 7500/7500E/FR4-18i platforms. The parameters displayed by this command
are set with the portCfg command. The following displays are supported with this command:
• portShow ipif - Displays the local IP interfaces
• portShow iproute - Displays static routes on the IP interfaces
• portShow arp - Displays content of the Address Resolution ARP table
Note On the on the Brocade 7800/FX8-24 platforms IPv6 addresses are not supported in the Fabric OS
v6.3.0 release.
You can display the content of the ARP table on the Brocade Extension platform but you cannot
modify this table with portCfg.
Operands This command has the following operands:
slot For bladed systems only, specifies the slot number of the port to be displayed,
followed by a slash (/).