Brocade Fabric OS Command Reference Manual Supporting Fabric OS v6.3.0 (53-1001337-01, July 2009)

Fabric OS Command Reference 743
53-1001337-01
portThConfig
2
For more information on port threshold configuration procedures, including default values for
specific area high/low thresholds, refer to the Fabric Watch Administrator’s Guide.
Operands This command has the following operands:
--set Configures the Fabric Watch thresholds for monitoring a specified area for all
ports of a specified port type. When configuring a threshold, you must specify
a port type and area.
--show Displays the threshold configuration or run-time status for all configured port
types and areas. You can optionally specify a port type to display the
threshold for ports of that type only. Or you can specify an area to display the
area-specific configuration only. When issued without operands, this
command displays all configured thresholds for all port types.
the following operands are required with the --set option and are optional
with the--show options.
port_type Specifies the port type for which to configure or display FabricWatch settings
or current status. Valid port types include one of the following:
e-port Configures or displays all E_Ports.
fop-port Configures or displays all optical F_Ports. Configuring copper
F_Ports is currently not supported.
port Configures or displays all physical ports.
-area area
Specifies the area monitored by the Fabric Watch daemon. The following
areas are valid when configuring or displaying configuration settings on
E_Ports, optical F_Ports, and physical ports. Area values are not
case-sensitive.
CRC Cyclic redundancy check error
ITW Invalid transmission word
C3TX_TO Class 3 discards frames due to timeout (8 G platforms only)
LOS Loss of synchronization
LF Link failure
RX Receive error
TX Transmit error
PE Protocol error
LR Link reset
ST State change
TU Trunk Utilization
ve-port Specifies the port type to be configured as a VE_Port. Only a subset of areas
can be configured for this port type.
-area ve_port_area
Specifies the area to be configured or displayed for a VE_Port. Configurable
areas for VE_Ports include the following: