Brocade Fabric OS Command Reference Manual Supporting Fabric OS v6.3.0 (53-1001337-01, July 2009)

Fabric OS Command Reference 841

53-1001337-01

supportShow

Displays switch information for debugging purposes.

Synopsis supportshow [[slotnumber/]portnumber1-portnumber2] [lines]

Description Use this command to display support information from groups of preselected Fabric OS and Linux

commands and other support and debugging information. You can specify the range of ports for

which to display this information. These commands are organized by groups, but note that the

order of the groups listed below is not the same as executed by the command.

SupportShow executes commands in the following command groups. Use supportShowCfgenable

or supportShowCfgDisable to modify the settings for each group.

os OS group commands, enabled by default.

exception Exception group commands, enabled by default.

port Port group commands, enabled by default.

fabric Fabric group commands, enabled by default.

services Service group commands, enabled by default.

security Security group commands, enabled by default.

network Network group commands, enabled by default.

portlog Portlog group commands, enabled by default.

system System group commands, enabled by default.

extend Extend group commands, disabled by default.

filter Filter group commands, disabled by default.

perfmon Performance Monitor group commands, disabled by default.

ficon FICON group commands, disabled by default.

iswitch FC Router group commands, disabled by default.

asic_db ASIC DB group commands, disabled by default.

iscsi iSCSI group commands, disabled by default.

fcip FCIP group commands, disabled by default.

ag Access Gateway group commands, disabled by default.

dce_hsl DCE group commands, enabled by default.

crypto Encryption group commands, disabled by default.

Notes The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may

be in place. Refer to chapter 1, "Using Fabric OS commands" and Appendix A, "Command

Availability" for details.

This is a diagnostic command and should only be run for diagnostic support.

Output generated by this command may vary by switch configuration and platform. Output may

change without notice.