Brocade Fabric OS Command Reference - Supporting Fabric OS v7.0.1 (53-1002447-01, March 2012)

Fabric OS Command Reference 271
53-1001764-01
fcipChipTest
2
fcipChipTest
Tests functionality of components in the FCIP complex.
SYNOPSIS fcipchiptest
[--slot slot]
[-testtype type]
[-unit number]
DESCRIPTION Use this command to verify the internal registers and memory of the network processor, FCIP FPGA,
compression processor, and GigPHY.
NOTES This command is supported only on the Brocade FR4-18i.
The execution of this command is subject to Virtual Fabric or Admin Domain restrictions that may be in
place. Refer to Chapter 1, "Using Fabric OS Commands" and Appendix A, "Command Availability" for
details.
OPERANDS This command has the following operands:
--slot slot
Specifies the slot number on which the diagnostic operates. The default is 0.
-testtype type
Specifies the test type to run. By default, the command runs all tests. Valid tests
include the following:
0
All tests
1
Network processor SRAM test
2
FCIP FPGA internal register test
3
FCIP FPGA interrupt test
4
FCIP FPGA checksum test
5
Compression engine MBIST and LBIST
-unit number
Specifies the GbE port to test. By default, all GbE ports in the specified slot are
used. Valid unit values include the following:
0
GbE port 0
1
GbE port 1
2
All GbE ports
DIAGNOSTICS When a failure is detected, the test might report one or more of the following error messages:
CHIP_TEST_ERR
CHIP_TEST_CHIP_INIT_ERR