Brocade Fabric OS Command Reference - Supporting Fabric OS v7.0.1 (53-1002447-01, March 2012)

648 Fabric OS Command Reference
53-1001764-01
portCfgEXPort
22
-m port mode
Specifies the port mode. The -m option enforces the same port mode for all the
ports connected to the same edge fabric. If this option is selected, the port mode
is compared against the online ports. If the modes are different, an error message
is posted, and the command fails. Valid values are as follows:
0
Brocade Native mode.
1
McDATA Open Fabric mode.
2
McDATA Fabric mode.
3
MCDATA fabric legacy mode.
5
Brocade Network OS fabric mode.
-i mode
Enables or disables Insistent Domain Id (IDID) for the specified EX_Port. Specify
1 to enable IDID, specify 2 to disable IDID. This command must be issued from a
McDATA edge switch attached to a single or dual FCR configuration.
EXAMPLES To set the fabric ID of port 2/1 to 5 and the port ID format to core:
switch:admin> portcfgexport 2/1 -f 5 -p 1
To configure port 2/0 to be an EX_Port and set the fabric ID to 4:
switch:admin> portcfgexport 2/0 -a 1 -f 4
To disable fabric parameter negotiation on port 2/0 of an EX_Port:
switch:admin> portcfgexport 2/0 -t 2
To enable IDID on port 2:
switch:admin> portcfgexport 2 -i 1
To display EX_Port settings configured for Mi10K connectivity:
switch:admin> portcfgexport 10
Port 10 info
Admin: enabled
State: OK
Pid format: Not Applicable
Operate mode: Open
Edge Fabric ID: 70
Preferred Domain ID: 239 mode
Front WWN: 50:00:51:e3:76:0e:4e:46
Fabric Parameters: Auto Negotiate
R_A_TOV: Not Applicable
E_D_TOV: Not Applicable
Authentication Type: None
DH Group: N/A
Hash Algorithm: N/A
Edge fabric's primary wwn: N/A
Edge fabric's version stamp: N/A