Brocade EZSwitchSetup Administrator's Guide v6.2.0 (53-1001193-02, April 2009)

EZSwitchSetup Administrator’s Guide 3
53-1001193-02
Supported switches
1
FIGURE 2 Configuring Internet Explorer
5. Click OK to save the changes.
Supported switches
You can use EZSwitchSetup with the following switches:
• Brocade 200E switch
• Brocade 300 switch
• Brocade 4100 switch
• Brocade 4900 switch
• Brocade 5000 switch
• Brocade 5100 switch
• Brocade 5300 switch
Your switch must meet the following requirements:
• It must be connected to an Ethernet LAN that is accessible by the host. If it is not, the system
issues the message “Page not Found.”
• It must be in a single-switch fabric. If your switch connects to another switch (if there is an
E_Port on the switch), you cannot manage the switch using EZSwitchSetup until you
disconnect the switch connection.
• It must be running Fabric OS v6.2.0.
NOTE
If there is an E_Port on the switch and if there is a zone conflict, then the fabric is segmented;
in this case, the switch is in a fabric by itself and EZSwitchSetup treats it as a single-switch
fabric.
Configure your browser to
check for newer versions of
stored pages on every visit to
the page.