Brocade EZSwitchSetup Administrator's Guide v6.2.0 (53-1001193-02, April 2009)

EZSwitchSetup Administrator’s Guide 7
53-1001193-02
Installing and running the EZSwitchSetup wizard
2
The EZSwitchSetup wizard starts, as shown in Figure 4.
FIGURE 4 EZSwitchSetup introduction screen
1. You have the choice of using a serial connection or an Ethernet connection to your LAN to set
the IP address for the switch. Choose the method you want to use for your installation. You may
want to use the serial connection if it is not possible or not convenient to connect the host on
the same subnet as the switch. Otherwise, the Ethernet connection is generally more
convenient and preferred.
2. Click Next.
The Connect Cables screen is displayed (Figure 5).