Brocade Web Tools Administrator's Guide - Supporting Fabric OS v5.3.0 (53-1000435-01, June 2007)

72 Web Tools Administrator’s Guide
Publication Number: 53-1000435-01
Enabling and disabling NPIV ports
5
To enable or disable a port over reboots
1. Click a port in the Switch View to open the Port Administration window.
2. Click the FC Ports or GigE Ports tab.
3. From the tree on the left, click the switch or slot that contains the port.
4. From the table, select one or more ports.
Use Shift-click and Ctrl-click to select multiple ports. You can select multiple ports from the
table. You cannot select multiple ports from the tree.
5. Click the Persistent Enable or Persistent Disable button.
If the button is gray (unavailable), the port is already in that state. For example, if the Persistent
Enable button is unavailable, the port or ports are already persistently enabled over reboots.
If you select multiple ports in both enabled and disabled states, both buttons are active. When
you click either button, the action is applied to all selected ports.
6. Click Yes in the confirmation window.
Enabling and disabling NPIV ports
N-Port ID Virtualization (NPIV) enables a single Fibre Channel protocol port to appear as multiple,
distinct ports, providing separate port identification within the fabric for each operating system
image behind the port (as if each operating system image has its own unique physical port). NPIV
assigns a different virtual port ID to each Fibre Channel protocol device. NPIV enables you to
allocate virtual addresses without impacting your existing hardware implementation. The virtual
port has the same properties as an N_Port, and is therefore capable of registering with all services
of the fabric.
The NPIV license must be installed on a switch before NPIV functionality can be enabled on any
port.
NOTE
NPIV enable/disable is not supported on EX_Ports.
To configure NPIV ports, see the Fabric OS Administrators Guide. Web Tools allows you only to
enable or disable the NPIV functionality on a port.
To enable NPIV ports
1. Click a port in the Switch View to open the Port Administration window.
2. Click the FC Ports tab.
3. From the tree on the left, select the logical port you want to enable.
4. Click the Enable NPIV button.
The button is unavailable if NPIV is already enabled on the port.
To disable NPIV ports
1. Click a port in the Switch View to open the Port Administration window.
2. Click the FC Ports tab.