Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

Fabric OS Message Reference 89
53-1000600-02
EM-1055
12
Probable Cause Indicates that an inconsistent state was found in the field-replaceable unit (FRU). This occurs if the
state of the FRU was changing during a failover. The FRU is reinitialized and traffic might have been
disrupted.
Recommended
Action
No action is required.
Severity INFO
EM-1055
Message <timestamp>, [EM-1055], <sequence-number>,, WARNING, <system-name>, <FRU Id>:
Port media incompatible. Reason: <Reason for incompatibility>
Probable Cause Indicates that an incompatible port media is detected.
The possible causes are:
• The port media is not capable of running at the configured port speed.
• The port media generates too much heat to be used in the slot.
Recommended
Action
Verify that the media can be run at the configured port speed.
If the port media is extended long wavelength, move it to a port that can support the heat
generated.
Severity WARNING
EM-1056
Message <timestamp>, [EM-1056], <sequence-number>,, WARNING, <system-name>, <FRU Id>:
Port faulted. Reason: <Reason code for the fault>.
Probable Cause Indicates a faulty port media is detected. The reason code for this message is for internal use only.
This message is valid for only the Brocade 4100, 4900, 5000, 7500, and AP7600.
Recommended
Action
Replace the defective small form-factor pluggable (SFP).
Severity WARNING
EM-1057
Message <timestamp>, [EM-1057], <sequence-number>,, WARNING, <system-name>, Blade:<Slot
Id> is getting reset:<Fault reason>.
Probable Cause The blade is automatically reset due to known resetable transient errors, such as an
application-specific integrated circuit.(ASIC) parity. error.