Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

146 Fabric OS Message Reference

53-1000600-02

FCR-1076

Message <timestamp>, [FCR-1076], <sequence-number>,, ERROR, <system-name>, Port <port

number> disabled, system only supports <maximum fds> front domains.

Probable Cause Indicates that the maximum number of supported front domains was exceeded. To enable the

specified port, disable any other operational front domain and then re-enable the port.

Recommended

Action

Make sure to remain within the maximum of supported front domains.

Severity ERROR

FCR-1077

Message <timestamp>, [FCR-1077], <sequence-number>,, WARNING, <system-name>, Port <port

number> rejected fabric binding request/check from the M-Model switch; <port

number>.

Probable Cause Indicates that an M-Model edge switch attempted to either activate or check the fabric binding.

This port will be disabled if this event occurred during a check of fabric binding and not during

failure to activate fabric binding. The error is caused when the binding list details configured on the

M-Model switch does not match with the currently configured front port domain ID and WWN of the

EX_Port on which this operation was attempted.

Recommended

Action

Ensure that the M-Model switch has the same currently configured details such as front port

domain ID and WWN of the EX_Port on which this operation was attempted.

Severity WARNING

FCR-1078

Message <timestamp>, [FCR-1078], <sequence-number>,, WARNING, <system-name>, LSAN name

<LSAN name> is too long. It is dropped.

Probable Cause The length of the LSAN name exceeds the limit of 64 characters.

Recommended

Action

Please change the name and reactivate the zone database.

Severity WARNING

FCR-1079

Message <timestamp>, [FCR-1079], <sequence-number>,, WARNING, <system-name>, Domain

<Domain> has conflict matrix database with local domain.

Probable Cause The indicated domain has different matrix database from local domain.