Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

160 Fabric OS Message Reference
53-1000600-02
FICN-1041
23
FICN-1041
Message <timestamp>, [FICN-1041], <sequence-number>,, ERROR, <system-name>,
HostTapeEgr:AS Link Level Reject (LRJ) from CU Rx Path=<FICON PATH>
LastCmd=0x<Last 4 commands issued to this device from the channel>
LastStatus=0x<Last 4 status values sent to the channel from this device>.
Probable Cause An LRJ received from a device indicates that the CU has lost the logical path to the LPAR.
Recommended
Action
If this was an unexpected event, please contact your vendor's customer support for assistance.
Severity ERROR
FICN-1042
Message <timestamp>, [FICN-1042], <sequence-number>,, WARNING, <system-name>,
HostTapeIng:FICON Cancel received Path=<FICON PATH> state=0x<the current
emulation state for this device>.
Probable Cause A job was cancelled during write
pipelining.
Recommended
Action
If this was an unexpected event (cancel is normally an operator event), please contact your
vendor's customer support for assistance.
Severity WARNING
FICN-1043
Message <timestamp>, [FICN-1043], <sequence-number>,, ERROR, <system-name>,
HostTapeIng::FICON Selective Reset:Path=<FICON PATH> state=0x<the current
emulation state for this device> LastCmds=0x<the last 4 commands received from the
channel for this device> LastStatus=0x<the last 4 status values presented to the
channel for this device>.
Probable Cause Protocol errors in emulation in the CU or network errors can cause Selective Reset.
Recommended
Action
If this was an unexpected event, please contact your vendor's customer support for assistance.
Severity ERROR
FICN-1044
Message <timestamp>, [FICN-1044], <sequence-number>,, ERROR, <system-name>,
HostTapeIng:FICON Selective Reset:Path=<FICON PATH> Elapsed Time=<the number of
seconds since the last IO started for this device>.<the number of milliseconds
since the last IO started for this device> seconds.