Manualshelf

Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

ManualsBrandsHP ManualsStorageBrocade BladeSystem 4/24 SAN Switch
221222223224225226227228229230
Fabric OS Message Reference 171
53-1000600-02
FICN-1080
23
FICN-1080
Message <timestamp>, [FICN-1080], <sequence-number>,, INFO, <system-name>,
DevTapeEgr:ReadCpReport:Path=<FICON PATH>:Emuls=0x<the number of idle state to
non-idle state transitions while this tape was loaded>:Cmds=0x<the number of
emulated host read commands processed while this tape was loaded>:Chains=0x<the
number of emulated host chains processed while this tape was loaded>:MBytes=<the
number of emulated read Kilobytes processed while this tape was loaded>.
Probable Cause A Rewind and Unload IO has been processed from a remotely connected LPAR and Read Channel
Program pipelining was performed on the currently loaded tape.
Recommended
Action
No action is required.
Severity INFO
FICN-1081
Message <timestamp>, [FICN-1081], <sequence-number>,, WARNING, <system-name>,
DevTapeIng:LRJ received on Path=<FICON PATH> lastCmds=0x<Last 4 commands received
from the channel for this device> lastStatus=0x<Last 4 status values presented to
the channel for this device> treating as system reset event.
Probable Cause An LRJ from a FICON channel indicates that the channel does not have a path established to the
CU.
Recommended
Action
This is normally an unexpected event, please contact your vendor's customer support for
assistance.
Severity WARNING
FICN-1082
Message <timestamp>, [FICN-1082], <sequence-number>,, WARNING, <system-name>,
EmulEls:CSWR_RSCN received on GEPort=<GEPortNumber> VEPort=<VEPortNumber>
Domain=0x<Domain Port Host> Port=0x<Device Side>.
Probable Cause An attached port which had an FICON emulated path established has logged out from the switch.
Recommended
Action
This may be an unexpected event, please contact your vendor's customer support for assistance.
Severity WARNING
FICN-1083
Message <timestamp>, [FICN-1083], <sequence-number>,, WARNING, <system-name>,
EmulEls:SW_RSCN received on GEPort=<GEPortNumber> VEPort=<VEPortNumber>
Domain=0x<Domain Port Host> Port=0x<Device Side>.