Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

Fabric OS Message Reference 183
53-1000600-02
Chapter
28
FSS System Messages
FSS-1001
Message <timestamp>, [FSS-1001], <sequence-number>,, WARNING, <system-name>, Component
(<component name>) dropping HA data update (<update ID>).
Probable Cause Indicates that an application has dropped a high availability (HA) data update.
Recommended
Action
Run the haSyncStart command if this is a dual-CP system, or reboot the switch if it is a nonbladed
system.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
FSS-1002
Message <timestamp>, [FSS-1002], <sequence-number>,, WARNING, <system-name>, Component
(<component name>) sending too many concurrent HA data update transactions
(<dropped update transaction ID>)
Probable Cause Indicates that an application has sent too many concurrent high availability (HA) data updates.
Recommended
Action
Run the haSyncStart command if this is a dual-CP system, or reboot the switch if it is a nonbladed
system.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
FSS-1003
Message <timestamp>, [FSS-1003], <sequence-number>,, WARNING, <system-name>, Component
(<component name>) misused the update transaction (<transaction ID>) without
marking the transaction beginning.
Probable Cause Indicates that the Fabric OS state synchronization (FSS) service has dropped the update because
an application has not set the transaction flag correctly.
Recommended
Action
Run the haSyncStart command if this is a dual-CP system, or reboot the switch if it is a nonbladed
system.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.