Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

192 Fabric OS Message Reference
53-1000600-02
FW-1011
30
Recommended
Action
Verify that you have installed the power supply correctly and that it is correctly seated in the
chassis. If the problem persists, replace the faulty power supply.
Severity WARNING
FW-1011
Message <timestamp>, [FW-1011], <sequence-number>,, INFO, <system-name>, <Label>, is
above high boundary(High=<High value>, Low=<Low value>). Current value is <Value>
<Unit>.
Probable Cause Indicates that the power supply is functioning properly.
Recommended
Action
Set the high boundary above the normal operation range.
Severity INFO
FW-1012
Message <timestamp>, [FW-1012], <sequence-number>,, INFO, <system-name>, <Label>, is
between high and low boundaries(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Probable Cause Indicates that the power supply counter changed from a value outside of the acceptable range to a
value within the acceptable range.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation.
Severity INFO
FW-1033
Message <timestamp>, [FW-1033], <sequence-number>,, INFO, <system-name>, <Label>, value
has changed(High=<High value>, Low=<Low value>). Current value is <Value> <Unit>.
Probable Cause Indicates that the temperature of the small form-factor pluggable (SFP) has changed. Frequent
fluctuations in SFP temperature might indicate a deteriorating SFP.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation.
Severity INFO
FW-1034
Message <timestamp>, [FW-1034], <sequence-number>,, WARNING, <system-name>, <Label>, is
below low boundary(High=<High value>, Low=<Low value>). Current value is <Value>
<Unit>.