Manualshelf

Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

ManualsBrandsHP ManualsStorageBrocade BladeSystem 4/24 SAN Switch
261262263264265266267268269270
212 Fabric OS Message Reference
53-1000600-02
FW-1173
30
Severity INFO
FW-1173
Message <timestamp>, [FW-1173], <sequence-number>,, INFO, <system-name>, <Port Name>,
<Label>, is below low boundary(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Probable Cause Indicates that the number of protocol errors that the port experiences has fallen below the low
boundary. Occasional protocol errors occur due to software glitches. Persistent protocol errors
occur due to hardware problems. A low number of protocol errors means that the switch is
functioning normally.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation.
Severity INFO
FW-1174
Message <timestamp>, [FW-1174], <sequence-number>,, WARNING, <system-name>, <Port Name>,
<Label>, is above high boundary(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Probable Cause Indicates that the number of protocol errors that the port experiences has risen above the high
boundary. Occasional protocol errors occur due to software glitches. Persistent protocol errors
occur due to hardware problems.
Recommended
Action
Check both ends of your connection. Verify that your cable and small form-factor pluggable (SFP)
are not faulty.
Severity WARNING
FW-1175
Message <timestamp>, [FW-1175], <sequence-number>,, INFO, <system-name>, <Port Name>,
<Label>, is between high and low boundaries(High=<High value>, Low=<Low value>).
Current value is <Value> <Unit>.
Probable Cause Indicates that the number of protocol errors that the port experiences has changed from a value
outside of the acceptable range to a value within the acceptable range. Occasional protocol errors
occur due to software glitches. Persistent protocol errors occur due to hardware problems.
Recommended
Action
No action is required. Respond to this message as is appropriate to the particular policy of the
end-user installation.
Severity INFO