Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

226 Fabric OS Message Reference
53-1000600-02
FW-1298
30
Probable Cause Indicates that the number of Telnet violations has fallen below the low boundary. Telnet violations
indicate that a Telnet connection request has been received from an unauthorized IP address. The
TELNET_POLICY contains a list of internet protocol (IP) addresses that are authorized to establish
Telnet connections to switches in the fabric.
Recommended
Action
No action is required.
Severity INFO
FW-1298
Message <timestamp>, [FW-1298], <sequence-number>,, WARNING, <system-name>, <Label>, is
above high boundary(High=<High value>, Low=<Low value>). Current value is <Value>
<Unit>.
Probable Cause Indicates that the number of Telnet violations has risen above the high boundary. Telnet violations
indicate that a Telnet connection request has been received from an unauthorized IP address. The
TELNET_POLICY contains a list of internet protocol (IP) addresses that are authorized to establish
Telnet connections to switches in the fabric.
Recommended
Action
Run the errShow command to determine the IP address that sent the request. Responses to
security-class messages depend on user policies. Consult your security administrator for response
strategies and policies.
Severity WARNING
FW-1299
Message <timestamp>, [FW-1299], <sequence-number>,, INFO, <system-name>, <Label>, is
between high and low boundaries(High=<High value>, Low=<Low value>). Current value
is <Value> <Unit>.
Probable Cause Indicates that the number of Telnet violations has changed from a value outside of the acceptable
range to a value within the acceptable range. Telnet violations indicate that a Telnet connection
request has been received from an unauthorized IP address. The TELNET_POLICY contains a list of
internet protocol (IP) addresses that are authorized to establish Telnet connections to switches in
the fabric.
Recommended
Action
No action is required.
Severity INFO
FW-1300
Message <timestamp>, [FW-1300], <sequence-number>,, INFO, <system-name>, <Label>, value
has changed(High=<High value>, Low=<Low value>). Current value is <Value> <Unit>.