Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

Fabric OS Message Reference 259
53-1000600-02
FW-1437
30
Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of
marginal ports is greater than or equal to the policy set using the switchStatusPolicySet command.
A port is faulty when the port value for Link Loss, Synchronization Loss, Signal Loss, Invalid word,
Protocol error, cyclic redundancy check (CRC) error, Port state change or Buffer Limited Port is
above the high boundary.
Recommended
Action
Replace any faulty or deteriorating small form-factor pluggables (SFPs).
Severity WARNING
FW-1437
Message <timestamp>, [FW-1437], <sequence-number>,, WARNING, <system-name>, Switch status
change contributing factor faulty ports: <Num of faulty ports>. (Port(s)
<unknown>.
Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of
faulty ports is greater than or equal to the policy set by the switchStatusPolicySet command. A port
is considered faulty due to hardware failure such as a faulty small form-factor pluggable (SFP) or
port.
Recommended
Action
Replace any faulty or deteriorating small form-factor pluggables (SFPs).
Severity WARNING
FW-1438
Message <timestamp>, [FW-1438], <sequence-number>,, WARNING, <system-name>, Switch status
change contributing factor Missing SFPs:
<Num of missing SFPs> missing SFPs.
Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the number of
missing small form-factor pluggables (SFPs) is greater than or equal to the policy set by the
switchStatusPolicySet command.
Recommended
Action
Run the switchStatusPolicySet command to modify the SFP policy or to add SFPs to the empty
ports.
Severity WARNING
FW-1439
Message <timestamp>, [FW-1439], <sequence-number>,, WARNING, <system-name>, Switch status
change contributing factor Switch offline.
Probable Cause Indicates that the switch status is not in a healthy state. This occurred because the switch is
offline.