Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

324 Fabric OS Message Reference
53-1000600-02
MS-1009
51
MS-1009
Message <timestamp>, [MS-1009], <sequence-number>,, ERROR, <system-name>, RLIR event.
Switch Port ID is <PID>. Device Port Tag is <port tag>. <message>.
Probable Cause A Registered Link Incident Record (RLIR) has been generated for one of the actions clarified by the
<message> passed in.
The following messages might be displayed:
Exceeded bit error rate threshold
Loss of signal or synchronization
Not operational seq. recognized
Primitive sequence timeout
Unrecognized link incident
Recommended
Action
Persistent RLIR incidents are likely due to SAN hardware problems such as bad cables, small
form-factor pluggables (SFPs), etc. It may be necessary to replace hardware if these messages
persist.
Severity ERROR
MS-1021
Message <timestamp>, [MS-1021], <sequence-number>,, ERROR, <system-name>, MS WARMBOOT
failure(FSS_MS_WARMINIT failed. Reason=
<failure reason>)
Probable Cause Indicates that the Fabric OS state synchronization (FSS) warm recovery failed during WARM INIT
phase of a reboot.
Recommended
Action
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity ERROR
MS-1022
Message <timestamp>, [MS-1022], <sequence-number>,, INFO, <system-name>, Management
Server Platform Service
<Activated or Deactivated>
Probable Cause Indicates that Management Server Platform Service is being activated or deactivated.
Recommended
Action
No action is required.
Severity INFO