Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

372 Fabric OS Message Reference
53-1000600-02
SEC-1037
66
SEC-1037
Message <timestamp>, [SEC-1037], <sequence-number>,, ERROR, <system-name>, Invalid WWN
format
<invalid WWN>.
Probable Cause Indicates that the world-wide name (WWN) entered in the policy member list had an invalid format.
Recommended
Action
Run the command again using the standard WWN format, 16 hexadecimal digits grouped as eight
colon separated pairs. For example: 50:06:04:81:D6:F3:45:42.
Severity ERROR
SEC-1038
Message <timestamp>, [SEC-1038], <sequence-number>,, ERROR, <system-name>, Invalid domain
<domain ID>.
Probable Cause Indicates that an invalid domain ID was entered.
Recommended
Action
Verify that the domain ID is correct, if not, then re-run the command using the correct domain ID.
Severity ERROR
SEC-1040
Message <timestamp>, [SEC-1040], <sequence-number>,, ERROR, <system-name>, Invalid
portlist (
<port list>). Cannot combine * with port member in the same portlist.
Probable Cause Indicates that the port list contains the wildcard asterisk (*) character. You cannot use the asterisk
in a port list.
Recommended
Action
Enter the port list values without any wildcards.
Severity ERROR
SEC-1041
Message <timestamp>, [SEC-1041], <sequence-number>,, ERROR, <system-name>, Invalid port
member <port member> in portlist (<port list>). <Reason>.
Probable Cause Indicates that the port member is invalid for one of the following reasons:
• The value is not a number.
• The value is too long. Valid numbers must be between one and three characters long.
• The value cannot be parsed due to invalid characters.
Recommended
Action
Use valid syntax when entering port members.