Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

Fabric OS Message Reference 381
53-1000600-02
SEC-1079
66
SEC-1079
Message <timestamp>, [SEC-1079], <sequence-number>,, ERROR, <system-name>, The policy
name
<policy name> is invalid.
Probable Cause Indicates that the policy name entered in the secPolicyCreate|Activate|Add|Delete command was
invalid.
Recommended
Action
Run the command again using a valid policy name.
Severity ERROR
SEC-1080
Message <timestamp>, [SEC-1080], <sequence-number>,, ERROR, <system-name>, Operation
denied. Please, use secModeEnable command.
Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR
SEC-1081
Message <timestamp>, [SEC-1081], <sequence-number>,, ERROR, <system-name>, Entered a name
for a DCC policy ID that was not unique.
Probable Cause Indicates that the device connection control (DCC) policy name given in the secPolicyCreate
command was the same as another DCC policy.
Recommended
Action
Make sure that the DCC policy name has a unique alpha-numeric string, and run the
secPolicyCreate command again.
Severity ERROR
SEC-1082
Message <timestamp>, [SEC-1082], <sequence-number>,, ERROR, <system-name>, Failed to
create
<policy name> policy.
Probable Cause Indicates that the security policy was not created due to faulty input or low resources.