Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

400 Fabric OS Message Reference
53-1000600-02
SEC-1168
66
Recommended
Action
Verify that the security event was planned. If the security event was planned, retry fabric
configurations server (FCS) failover after current failover has completed, if this switch should
become primary FCS. If the security event was not planned, take appropriate action as defined by
your enterprise security policy.
Severity ERROR
SEC-1168
Message <timestamp>, [SEC-1168], <sequence-number>,, ERROR, <system-name>, Primary FCS
failover is busy. Please retry later.
Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity ERROR
SEC-1170
Message <timestamp>, [SEC-1170], <sequence-number>,, INFO, <system-name>, This command
must be executed on the Primary FCS switch, the first reachable switch in the FCS
list.
Probable Cause Indicates that there has been a corruption during the distribution of the security database. This can
only occur when the primary fabric configurations server (FCS) is distributing the security database
to the other switches in the fabric and local validation finds that there is an error in the security
database. This is a rare occurrence.
Recommended
Action
Run the secFabricShow command to verify that the fabric is still consistent. All the switches should
be in the ready state. If a switch is in the error state, the database might not be correctly updated
for that specific switch.
Severity INFO
SEC-1171
Message <timestamp>, [SEC-1171], <sequence-number>,, ERROR, <system-name>, Disabled
secure mode due to invalid security object.
Probable Cause Indicates that the switch is segmented, and secure mode is disabled on the switch because there
was no license present or no public key infrastructure (PKI) objects.
Recommended
Action
Run the pkiShow command to check if all PKI objects exist. If they do not exit, run the pkiCreate
command to create them for the switch.