Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

Fabric OS Message Reference 431
53-1000600-02
SULB-1009
69
The following section explains the causes of some common error messages:
0x15 - Failed to download Red Hat package manager (RPM) package. If this error occurs
immediately after firmwareDownload is started, the firmware on the switch may be two releases
older than the requested firmware. firmwareDownload supports firmware upgrades within two
feature releases (a feature release is indicated by a major number and a minor number, for
example, X.Y). The following are major upgrade versions for the Fabric OS: v4.0, v4.1, v4.2, v4.4,
v5.0, v5.1.,5.2, and 5.3. In this case, you will need to upgrade to an intermediate version before
downloading the desired version. If this error occurs in the middle of firmwareDownload, the
firmware in the file server may be corrupted or there may be a temporary network issue. In this
case, retry the firmwareDownload command. If the problem persists, contact your system
administrator.
0x18 - Error in getting lock device for firmwareDownload. This error may occur because another
firmwareDownload is already in progress. Run firmwareDownloadStatus to verify that this is the
case. Wait for the current session to finish before proceeding.
"Both images are mounted to the same device." 0x20
“Unable to unionist old packages.” 0x21
firmwareDownload is already in progress.” 0x22
firmwareDownload timed out.” 0x23
"Our of disk space." 0x24
“Primary filesystem is inconsistent. Run firmwareRestore to restore the original firmware, or
contact your service provider for recovery.”
0x25
"The post-install script failed." 0x26
"Unexpected reboot." 0x27
"Primary kernel partition is inconsistent. Please contact your service provider for recovery." 0x28
"The pre-install script failed." 0x29
“The platform option is not supported. Run chassisConfig to reset the option first and then try
firmwareDownload.”
0x2a
"Failed to install RPM package." 0x2b
"Cannot downgrade directly to this version. Downgrade to an intermediate version first and then
download the desired version."
0x2c
“Cannot download 5.1 because Device Based Routing policy is not supported by 5.1. Use
aptPolicy to change the routing policy before proceeding.”
0x2d
"Invalid RPM package. Please reload firmware packages on the file server." 0x2e
"Cannot downgrade due to presence of blade type 17. Remove or power off these blades before
proceeding."
0x2f
"Cannot downgrade due to presence of blade type 24. Remove or power off these blades before
"
0x30
"Cannot downgrade due to presence of long-distance ports in LS mode. Please remove these
settings before proceeding."
0x31
"Network is not reachable. Please verify the IP address of the server is correct." 0x32
TABLE 7 Error Messages and Error Codes
Error Message Error Code