Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

Fabric OS Message Reference 441
53-1000600-02
SWCH-1008
70
Recommended
Action
Based on the disable reason displayed, proper corrective action may to be required to restore the
port.
If insufficient frame buffers is the disable reason, reduce the distance or speed settings for the
port to reduce the buffer requirement of the link. Alternatively, one or more ports in the port group
must be disabled to make more buffers available for the link.
Please refer to the Fabric OS Administrator’s Guide for more information about buffers.
Severity WARNING
SWCH-1008
Message <timestamp>, [SWCH-1008], <sequence-number>,, WARNING, <system-name>, <area
string> are port swapped on ports that do not support port swap. Slot <slot
number> will be faulted.
Probable Cause Indicates that the blade is enabled with the port configuration that already has area swapped.
Recommended
Action
Replace the blade with ports that support port swap. Then port swap the ports back to ports
default area.
Refer to the Fabric OS Administrator’s Guide for more information on port swapping.
Severity WARNING
SWCH-1009
Message <timestamp>, [SWCH-1009], <sequence-number>,, WARNING, <system-name>, Shared area
having Trunk Area (TA) enabled on slot <slot number>. Shared areas that have TA
enabled will be persistenly disabled.
Probable Cause The blade is enabled with a port configuration that had Trunk Area enabled on shared area port
previously.
Recommended
Action
User has to disable Trunk Area on ports that had Trunk Area enabled previously.
Refer to the Fabric OS Administrator’s Guide for more information.
Severity WARNING
SWCH-1010
Message <timestamp>, [SWCH-1010], <sequence-number>,, WARNING, <system-name>, Trunk Area
(TA) enabled on slot <slot number> with switch not in PID format 1. TA enabled
ports will be persistently disabled.
Probable Cause The blade is enabled with the port configuration that had Trunk Area enabled previously.
Recommended
Action
User has to disable Trunk Area on ports that had Trunk Area enabled previously.
Refer to the Fabric OS Administrator’s Guide for more information.