Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

Fabric OS Message Reference 449

53-1000600-02

TRCE-1007

Message <timestamp>, [TRCE-1007], <sequence-number>,, ERROR, <system-name>, Notification

of this CP has failed. Parameters temporarily out of synch with other CP.

Probable Cause Indicates that the active CP is unable to alert the standby CP of a change in trace status. This

message is only applicable to the Brocade 24000, and 48000.

Recommended

Action

This message is often transitory. Wait a few minutes and try the command again.

If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the

supportSave command and contact your switch service provider.

Severity ERROR

TRCE-1008

Message <timestamp>, [TRCE-1008], <sequence-number>, FFDC, CRITICAL, <system-name>,

Unable to load trace parameters.

Probable Cause Indicates that the active CP is unable to read stored trace parameters.

Recommended

Action

Reboot the CP (dual-CP system) or restart the switch.

If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the

supportSave command and contact your switch service provider.

Severity CRITICAL

TRCE-1009

Message <timestamp>, [TRCE-1009], <sequence-number>,, ERROR, <system-name>, Unable to

alert active CP that a dump has occurred.

Probable Cause Indicates that the standby CP is unable to communicate trace information to active CP. This

message is only applicable to the Brocade 24000 and 48000.

Recommended

Action

Run the haShow command to verify that the current CP is standby and the active CP is active.

If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the

supportSave command and contact your switch service provider.

Severity ERROR

TRCE-1010

Message <timestamp>, [TRCE-1010], <sequence-number>,, ERROR, <system-name>, Traced fails

to start