Brocade Error Message Reference Guide v6.1.0 (53-1000600-02, June 2008)

30 Fabric OS Message Reference
53-1000600-02
AG-1026
2
AG-1026
Message <timestamp>, [AG-1026], <sequence-number>,, WARNING, <system-name>, Unable to
handle the login request on port <port> due to insufficient resources.
Probable Cause Insufficient resources.
Recommended
Action
Run configure CLI on AG switch and increase the number of allowed logins on this port.
If the message persists, run supportFtp (as needed) to set up automatic FTP transfers; then run the
supportSave command and contact your switch service provider.
Severity WARNING
AG-1027
Message <timestamp>, [AG-1027], <sequence-number>,, WARNING, <system-name>, Unable to
handle this login request on port <port> because NPIV capability is not enabled on
this port.
Probable Cause NPIV not enabled.
Recommended
Action
Run portcfgnpivport CLI on AG switch and enable the NPIV capability on this port.
Severity WARNING
AG-1028
Message <timestamp>, [AG-1028], <sequence-number>,, WARNING, <system-name>, Device with
Port WWN <port_name> tried to perform fabric login through port <fport>, without
having access permission.
Probable Cause Device does not have access to login as per ADS policy set by user for that port.
Recommended
Action
Add the device in to the ADS allow list for that port using ag --adsadd command.
Severity WARNING