Brocade Web Tools Administrator's Guide v6.0.0 (53-1000606-01, April 2008)

Web Tools Administrator’s Guide 137
53-1000606-01
Viewing and configuring EX_Ports
10
For Brocade switches, this launches Web Tools. For non-Brocade fabrics, this launches the element
manager for that switch.
FIGURE 59 FC Routing module with LSAN Fabrics tab selected
Viewing and configuring EX_Ports
The EX_Ports tab (see Figure 60 on page 138) displays all of the EX_Ports on the switch, including
configuration and status information. The ports are sorted by slot number, and then by row number
within each slot. IP addresses information is displayed in both IPv4 and IPv6 format.
NOTE
If FC Routing is disabled, then you have to disable all of the EX_Ports and you cannot enable them
until FC Routing is enabled.
For more detailed information about a specific port, click a port name in the table and then click
View Details in the task bar. You can also click the port name in the tree on the left side of the
window.
From the EX_Ports tab, you can perform the following port management tasks by selecting a port in
the table and then clicking a task in the task bar:
• “Configuring an EX_Port” on page 138
• “Editing the configuration of an EX_Port” on page 139
• Rename an EX_Port.
• Swap the Port Index of an EX_Port (described in “Swapping port index” on page 74).