Brocade Web Tools Administrator's Guide v6.0.0 (53-1000606-01, April 2008)

Web Tools Administrator’s Guide 173
53-1000606-01
Setting up iSCSI Target Gateway Services
14
When you select one of the GbE ports, you can perform the same tasks listed previously: view and
capture statistics related to the port, add or delete IP addresses, add or delete IP routes, view
current sessions, and view the iSCSI statistics in brief.
FIGURE 77 iSCSI Port tab
If an IP address or IP route is already configured on the GbE port, then it will not be editable as any
edits will disrupt any iSCSI traffic.
Configuring the IP route is optional because when an IP address is set up, a route is automatically
set up as well.
1. Open iSCSI Target Gateway Admin as described on page 171.
2. Select the iSCSI Port tab.
3. In the left pane, select the GbE port that will be used.
4. Select the IP Interface subtab and click Add.
5. Enter the IP address and subnet mask.
6. Enter the MTU size or accept the default MTU size and click Add.
Editing an IP Address
1. Launch the iSCSI Target Gateway Admin module as described on page 171.
2. Select the iSCSI Port tab.
3. From the left pane, select the GbE port that will be used.