Brocade Web Tools Administrator's Guide v6.0.0 (53-1000606-01, April 2008)

Web Tools Administrator’s Guide 191
53-1000606-01
Changing Access Gateway policies
15
FIGURE 90 F-N Port Mapping Configuration dialog box
4. In the Primary Mappings area, select ports and use the Add button to map F-Ports or U-Ports to
N-Ports.
Use the Remove button to remove an F-Port mapping from an N-Port.
5. To define a Secondary N_port in the Secondary Failover Mappings area, select the ports and
use the Add and Remove buttons to set up the secondary mappings.
The F_Port will be fail over to the Secondary N_Port if the primary mapped N_Port is offline.
This step is optional. You do not have to define a secondary failover mapping for each F_Port.
The secondary mappings must be to a different N-Port in the same group as the primary
mapping. If a Secondary N_Port is not defined, the F_Port failover is to any online N_Port.
6. When you have made the appropriate changes, click Save.
Changing Access Gateway policies
Although you can control a number of policies in Access Gateway mode, Web Tools only provides
the ability to enable and disable the policies. For more information on these policies please refer to
Brocade Access Gateway Administration Guide.