Brocade Web Tools Administrator's Guide v6.0.0 (53-1000606-01, April 2008)

30 Web Tools Administrator’s Guide
53-1000606-01
Configuring IP and netmask information
3
Configuring IP and netmask information
When you configure IP and netmask information for the Brocade 48000 and Brocade DCX Director,
you must configure IP and subnet mask information individually.
When you change the Ethernet IP, subnet mask, gateway IP, or Fibre Channel IP and subnet mask
from Web Tools, there is a normal loss of network connection to the switch. If the IP properties have
changed, you must close all current windows and restart Web Tools with the new IP address.
1. Open the Switch Administration window as described on page 29.
2. Click the Network tab.
FIGURE 17 Network tab
3. In the appropriate IP address section, enter an IP address (for example, 10.77.77.77).
Use the IPv4 Address section and/or the IPv6 Address section to specify IP addresses.
4. For the Brocade 48000 directors only:
In the Advanced Configuration area, type valid IP addresses for the Ethernet IP and subnet
mask for CP0 and CP1.
If the Advanced Configuration area is not visible, click the expand arrows on the right, to
expand the area.
5. Click Apply.
6. Click Close to exit, and then restart Web Tools to continue working.