HP StorageWorks Fabric OS 5.0.0 Command Reference Guide (AA-RW1MA-TE, May 2005)

152 Fabric OS commands
Initializes the blade for a burn-in run.
Synopsis
diagsetburnin [--slot slotnumber][script | -current]
Availability
admin
Description
This sets up the blade burn-in parameters for the registered burn-in script. The burn-in will start at the next
run of power-on self-test (POST) on the designated blade(s).
The errors and activity logs are stored in flash memory. The activity log of the script is saved in
/var/log/scriptname.slot.log. The errors produced are available from the burninErrShow command on
a per-blade basis. When power cycles occur, the burn-in activity is restarted at the test that was interrupted
at the time of the power cycle. This command does not require a reboot to take effect.
NOTE: Boards must be installed prior to running this command and diagSetCycle must be run prior to
diagSetBurnin if you want to use both commands.
Operands
This command has the following operands:
Examples
To set the burn-in script and mode:
See also
burninErrShow
diagSetCycle
diagSetBurnin
--slot slotnumber Specify which slot number to update. If this option is not
specified at all, then all slots on the switch are set up for burn-in.
script Specify the name of the burn-in script to run.
-current Set the name of burn-in script to current burn-in script.
switch:admin> diagsetburnin --slot 1 -current
existing script is: /fabos/share/switchess.sh
Burnin mode is Enabled.
Removing all log files in /var/log for slot 1
Slot 1 burnin name is now /fabos/share/switchess.sh
Config update Succeeded