HP StorageWorks Fabric OS 5.0.0 Command Reference Guide (AA-RW1MA-TE, May 2005)

Fabric OS 5.0.0 command reference guide 157
Enables or disables silkworm mode.
Synopsis
diagsilkworm [mode | -show]
Availability
admin
Description
Use this command to enable silkworm mode (if the mode value is not 0) or disable the silkworm mode (if
the mode value is 0). The mode is saved in flash memory (and stays in that mode) until the next execution
of diagSilkworm. The mode becomes active as soon as this command is executed; it does not require a
reboot to take effect.
Silkworm mode, when enabled, notifies the diagnostics environment and test methods that the tests are
running in silkworm mode. For proper operation, FCSW mode also must be disabled.
NOTE: This mode cannot be used by burn-in or POST scripts for multi-blade systems because it is a
switch-wide configuration.
Operands
This command has the following operands:
If no operand is specified, the current value is displayed.
Examples
To enable silkworm mode:
Note
This mode might not be used by burn-in or POST scripts for multiblade systems because it is a switch-wide
configuration.
diagSilkworm
mode Specify 1 to enable silkworm mode; specify 0 to disable
silkworm mode. This operand is optional.
-show Specify this operand to display the current mode setting. This
operand is optional.
switch:admin> diagsilkworm -show
Silkworm mode is 0 (Disabled).