HP StorageWorks Fabric OS 5.0.0 Command Reference Guide (AA-RW1MA-TE, May 2005)

176 Fabric OS commands
Operands
This command has the following operands:
Flags Port flags:
0x00000001 Slave connection
0x00000002 Loopback connection
0x00000004 Incompatible connection
0x00000008 Overlapping domains
0x00000010 Overlapping zones
0x00000020 Done PTIO ioctl
0x00000040 Sent an RJT to ELP
0x00000080 BF received from the port
0x00000200 Segmented by routing code
0x00000800 Zoning has completed
0x00001000 Segmented by Platform Management
0x00002000 Segmented due to no license
0x00004000 Segmented due to E_Port disabling
0x00008000 DIA already sent for that port
0x00010000 RDI already sent
0x00020000 Port is true T port
0x00040000 Port received an ELP
0x00080000 Port received an ELP RJT
0x00100000 LR pending due to ELP RJT rcv
0x00200000 Received a DIA on this port
0x00400000 Port is the EMT Initiator
0x00800000 Security violation
0x01000000 Security incompatibility
0x02000000 Rcv a DIA ACC
0x040000000 Port is security authenticating
0x080000000 ECP RJT or retires exceeded
0x100000000 Segmented due to duplicated WWN
0x200000000 Segmented due to E_Port isolation
nbrWWN Neighboring switch's WWN
nbrPort Neighboring switch’s port
lr_tid Link reset timer identifier and current state.
red_ports All E_Ports that are connected to the same neighboring switch
slotnumber Specify the slot number for a Core Switch 2/64 or SAN Director
2/128. For all other switches, this operand is not required. The
slot number must be followed by a slash ( / ) and the port
number.
The HP StorageWorks director has a total of 10 slots. Slot
numbers 5 and 6 are control processor (CP) cards, and slots 1
through 4 and 7 through 10 are port cards. There are 16 ports
on each port card, counted from the bottom up, 0 to 15.
portnumber Specify a port number. Valid values for port number vary,
depending on the switch type. This operand is required.