HP StorageWorks Fabric OS 5.0.0 Command Reference Guide (AA-RW1MA-TE, May 2005)

Fabric OS 5.0.0 command reference guide 207
Displays the Fibre Channel Protocol (FCP) probe information.
Synopsis
fcpprobeshow [slotnumber/]portnumber
Availability
all users
Description
Use this command to display the FCP probing information for a particular device, which should be of type
F/FL_Port. If the given port is not either, then the following is displayed:
port x is not an FL_Port or an F_Port
Operands
This command has the following operands:
fcpProbeShow
slotnumber Specify the slot number for a Core Switch 2/64 or SAN Director
2/128. For all other switches, this operand is not required. The
slot number must be followed by a slash ( / ) and the port
number, so that each port is represented by both slot number (1
through 4 or 7 through 10) and port number (0 through 15).
The Core Switch 2/64 and SAN Director 2/128 have a total of
10 slots. Slot numbers 5 and 6 are control processor cards; slots
1 through 4 and 7 through 10 are port cards. On each port
card, there are 16 ports, counted from the bottom, numbered 0
to 15.
portnumber Specify a port number. Valid values for port number vary,
depending on the switch type. This operand is required.