HP StorageWorks Fabric OS 5.0.0 Command Reference Guide (AA-RW1MA-TE, May 2005)

Fabric OS 5.0.0 command reference guide 209
Display the Fibre Channel Protocol (FCP) Read Link Status (RLS) information.
Synopsis
fcprlsshow [slotnumber/]portnumber
Availability
all users
Description
Use this command to display the FCP RLS information for a particular device, which should be either an F_
or FL_Port. If the given port is not either of these the following displays:
port x is not an FL_Port or an F_Port
Operands
This command has the following operands:
Examples
To display the FCP RLS information:
See also
portLoginShow
portLogShow
fcpRlsShow
slotnumber Specify the slot number for a Core Switch 2/64 or SAN Director
2/128. For all other switches, this operand is not required. The
slot number must be followed by a slash ( / ) and the port
number, so that each port is represented by both slot number (1
through 4 or 7 through 10) and port number (0 through 15).
The Core Switch 2/64 and SAN Director 2/128 have a total of
10 slots. Slot numbers 5 and 6 are control processor cards; slots
1 through 4 and 7 through 10 are port cards. On each port
card, there are 16 ports, counted from the bottom, numbered 0
to 15.
portnumber Specify a port number. Valid values for port number vary,
depending on the switch type. This operand is required.
switch:admin> fcprlsshow 2/5
link fail loss sync loss sig prtc err bad word crc err
0xda 0 5 0 0 525 0
0xdc 0 3 0 0 330 0