HP StorageWorks Fabric OS 5.0.0 Command Reference Guide (AA-RW1MA-TE, May 2005)

Fabric OS 5.0.0 command reference guide 415
Displays port-based filter CAM utilization.
Synopsis
portcamshow [slotnumber/][portnumber]
Availability
all users
Description
Use this command to display the current filter CAM utilization of all ports or one port specified at input.
The following information is displayed:
Operands
This command has the following operands:
portCamShow
SID used Display total number of CAM entries used by this port. Note that each
CAM entry (either SID or DID CAM) can be shared among ports in the
same quad.
DID used Display total number of CAM entries used by this port. Note that each
CAM entry (either SID or DID CAM) can be shared among ports in the
same quad.
SID entries Display all existing source ID entries within the CAM per quad. Note that
each CAM entry (either SID or DID CAM) can be shared among ports in
the same quad.
DID entries Display all existing destination ID entries within the CAM per quad. Note
that each CAM entry (either SID or DID CAM) can be among ports in the
same quad.
SID free Display the total number of free SID CAM entries per quad.
DID free Display the total number of free DID CAM entries per quad.
slotnumber Specify the slot number for a Core Switch 2/64 or SAN Director
2/128. For all other switches, this operand is not required. The slot
number must be followed by a slash ( / ) and the port number, so that
each port is represented by both slot number (1 through 4 or 7 through
10) and port number (0 through 15).
The Core Switch 2/64 and SAN Director 2/128 have a total of 10
slots. Slot numbers 5 and 6 are control processor cards; slots 1 through
4 and 7 through 10 are port cards. On each port card, there are 16
ports, counted from the bottom, numbered 0 to 15.
portnumber Specify a port number. Valid values for port number vary, depending
on the switch type. This operand is optional.